Trail-tech 1 1/8" HANDLEBAR CLAMPS 030-H700F Bedienungsanleitung PDF herunterladen

BAR CLAMP REPLACEMENT TIPS:

• Stock indicator lights: Carefully remove the colored

plastic caps with a small screwdriver, then push the

rubber boot down through the hole. To install the

rubber boots into the TrailTech clamp, apply a bead of

water or alcohol for lubrication.

• Stem Cover: On the steering stem, there are 2

welded wire tabs (See photo below.) The tabs will

either need to be removed, or the stem cover will need

to be modiﬁed to ﬁt over the tabs. To remove the tabs,

bend them off with a pair of pliers, then use a grinder to

remove any sharp edges.

HONDA TRX700XX BAR CLAMPS

TORQUE VALUES:

Use OEM torque specs when at-

taching clamps to the steering stem.

The four top clamp bolts should be

torqued to 20 ft. lbs.

TIP:

IF ALSO INSTALLING A TRAIL TECH SPEEDOMETER:

BAR CLAMP, X-BARS, AND VAPOR PROTECTOR

INSTALLED ON HONDA TRX700XX

010-ELV-22

Trail Tech TRX700XX Bar Clamps

Tech Support: 360-687-4530

• Bar Clamp: Install the stem cover ﬁrst. Next, attach

lower portion of the Trail Tech bar clamp to the steering

stem. Place 1 1/8” bars in the cradle and secure with

TrailTech top clamp. Some controls may need to be

placed on the bars before the bar is installed.

REMOVING WELDED WIRE TABS

HONDA TRX700XX

TRAIL TECH SPEEDOMETER SPEED SENSOR

INSTALLED ON HONDA TRX700XX

TRAIL TECH SPEEDOMETER TEMPERATURE SENSOR

INSTALLED ON HONDA TRX700XX

BAR CLAMP REPLACEMENT TIPS:• Stock indicator lights: Carefully remove the colored plastic caps with a small screwdriver, then push the rubber boot d

Keine Kommentare

Trail-tech 1 1/8" HANDLEBAR CLAMPS 030-H700F Bedienungsanleitung